![]() ![]() Mac/Linux - Select the SilconLabs driver from the dropdown list. Note: The RTS +12v and DTR +12v boxes do not need to be selected. That will select the default settings which will be good for starters. It will come up with just a basic display.Ĭhoose the 7300 from the Rig dropdown list. With the radio on and the USB cable connected and no other communications program running, Start flrig. For Mac and Linux install them as you would any other application. Putting them in other folders can causes permissions issues sometimes on Windows 10. You should have already installed the driver for the built-in sound card in the 7300.Ĭonnect the transceiver to the computer with a USB A-Male to B-Male cable and turn on the radio.įor Windows flrig will install to it's own folders and should be installed in the normal application folder where other applications are installed. Response will be a bit quicker with higher rates, but it will do well at 19,200 also. I use 115,200, but use 19,200 for starters as that is what flrig defaults to. Many of these are ok at default, but verify the ones listed below:ĬI-V USB Baud Rate - 19,200. Once the above are set then touch the CI-V line on screen to get a list of items to set especially for CAT control. See the fldigi manual on setting up the sound levels. Something to play with to make it work best for you. Too much and you overdrive fldigi and decoding suffers, too little and you may miss weak signals though fldigi does very well with very weak signals. This is the built-in soundcard in the radio output level that goes into fldigi on receive. How to fine tune it will be explained later.ĪCC/USB AF Output level - I have mine set at 80%. This is the input level control for the TX sound from the computer. USB MOD Level - I have mine set at 28% so you might try this for starters. This applies only when the rig is not in data mode. Make sure the settings for these items are as follows:ĭata Off Mod - Mic, ACC or just Mic if you wish. Press the transceiver MENU button then the on screen items: Set, then Connectors. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |